Warden Corset Mark 2

Behold, the Warden Mark 2 corset. The corset is a new version of the 1st Warden made in 2000.

The new Warden is similar in design to the original model. The finished corset is lined with black cotton poly twill. The exterior is black leather. The front closure is my design of the stayed zipper. This allows easy entrance and egress of the corset. Underneath the stayed zipper is a heavy underbusk. The underbusk is a stiff piece of steel that I cut to the proper length, roll the edges, latex tip and form into a proper curve. (This feature is used in all my corsets) Adjustment of the corsets' tension upon the torso is accomplished by the rear laces. The metal stays are custom sized at the studio, and run strategic lengths of the corset. This allows the wearer to sit, move about, and roll his shoulders.

The lower torso portion has a lined crotch-piece that is adjustable and removable. Adjustment is via heavy buckle system at the back.

The leg portions of the corset extend down to just where the knee begins. This portion is laced down the inside to the thighs and provide the desired compression. The legs are fully lined with cotton poly twill. Steel stays run the full length of the legs as well.

The rear pelvic section was made with a bit of allowance to allow the wearer to sit. If the allowance was not there, the corset would be so stiff that he would not be able to sit comfortably.